This is another quilt I should have put up on my design wall before quilting it, because the colors and the pattern are striking.
Kathy called this her Universe quilt. It has the 4 quadrants in colors. Do you see the circles of color in the blues down in the lower left? Those look like planets, too, and all the mottled batiks in the borders look, to me, like an Aurora Borealis. So, how would you quilt this?
The colors are so magnificent, that it’s hard to see the quilting, but I decided to stitch a stun into the upper right hand (yellow) corner with the 9 planets circling around it. The orbiting circles are anything but perfect. I hand drew them on with chalk and then stitched following the chalk lines.
In the purple down in the lower right is where I put Earth and its circling moon. Can you see it? The moon’s orbit is elliptical, so maybe if you find that semi-sideways oval, you’ll see the big circle inside, which is Earth. I also drew the Big and Little Dipper with the North Star to the lower left of Earth. Of course, my ADD brain struggled with which way to put those stars (they’re not in correct proportion anyway)…as I am looking at them on the quilt? Or as I would look at them if I were on Earth? I also put shooting stars and meteors in the quilt, but you can’t see them here. The backing on the quilt did a good job of hiding them, too, which I’m always glad for, because my pea brain talks smack to me about my quilting abilities.
This particular quilt was a good example of some of the strategies I used for getting a quilt squared up as it rolls on the frame for the quilting machine. And, since you can’t see the quilting too much, I thought I’d add some tips here.
First off, this quilt has lots of straight lines. I use those lines to guide me to getting the quilt straight. I’ll explain the tape measure in a bit, but for now, take a look at the lower edge of the picture. That’s where the lower roller bar lies. I use the lines in the quilt to help me gauge whether or not the quilt is straight going across.
I’m sure I’ve showed you before the laser level I use to make sure the lines are straight as well.
I used to use these white clips on the rear roller bar to help me with placement of blocks and borders as I quilted, but, unless you find a way to make them stay put, they roll and move. By the way, if you look closely at the edges of the quilt top, you will see a line of basting on the batting. There are 3 roller bars on my machine’s frame. The backing fabric is attached to 2 rollers; one at the bottom and one above this black roller you see in the picture below. That roller is used to keep the fabric in place at it rolls. So, first, I attach the backing fabric to the canvases that are attached to those 2 rollers. Then, I lay the batting on top of the backing fabric. I use my channel locks to stitch a straight line across the top of the batting – it helps to have a dark thread for this so you can see it better. That is my guide for where to butt the quilt top fabric up against. I then pin the quilt top fabric in place and then stitch it down about 1/4 inch along the edge. I’d like to make it 1/8 inch, but I’m just not that good.
As for the tape measure, I use that as a guide for where to stitch the sides in place. When I get the top stitched down, I use my laser level to tell me where to butt the sides up to and then stitch the sides down to about 12 inches from the top. Then I see where the sides hit the tape measure and write those numbers down. I use those numbers for placement of the rest of the quilt along the sides.
A machine quilter’s job involves a lot more than just quilting. The above tips are just a sampling of the many things we do when we work on your quilt.